|
Crossed Rods Indicate Target |
Move Collector Rods Closer to Locate Target |
Final Scan
Easy to Locate Target |
|
The reciprocating signal between the scanner and the target now becomes the traceable roadway for the operator to located thetarget. This process requires only several minutes to determine if there are any suitable targets within the normal operating range of the scanner. Please remember that the range depends on the suze of the buried target, signals are RF by nature, heavy solar activity will diminish the signal to a small degree.
Power Transducer-- This unit is responsible for delivering the selected signal of the Scanner to the ground plane of the strata via the two copper legs which are plugged into the ground. The coax lead is the power supply line and attaches to the output of the Scanmaster.
Power Module -- This unit's purpose is to power the Antenna Rods. The unit contains a 9VDC battery for a power supply. The battery condition is displayed when the Push Button on top is pressed in. If the top indicator light is bright, the battery is okay. If is is dim or out, the battery needs replaced. To replace the 9 volt battery, simply open the module by rotating the bottom cap off. The power module is turned on when the receiving Antenna Rods are plugged in the Power Module's receptacle. When not in use, unplug the Rods from the Power Module! Storing the Power Module with the Rods plugged in will drain the 9 volt battery. Do not allow the Rods to touch each other while attached to the module as this will short out the battery also!
Receiving Antenna Rods-- The rods are powered by the Power Module. The purpose of the Rods is to indicate to the Operator that he or she has walked into the transmission line between the Power Transducer and the Target. The rods are normally held steady and balanced at waist level, and slightly in front of the Operator. They are held pointed in a forward direction parallel to each other, and at a distance of 8 to 18 inches apart. What each individual needs to discover is just what distance best relates to themselves. This decision will be by trial and error. Please remember that an individual who is relaxed and calm will operate the equipment more successfully than one who is tense and rigid The rods will cross naturally by themselves when you enter the RF Energy line. When it first happens for you, you will learned to anticipate success and will welcome it when it happens!
Collectors -- These four devices are used as passive repeaters to aid in pinpointing the location of targets. They are "passive: in that they require no power supplies and simply pick up the Scanner's initial signal and pass it on to the target. Initially, the primary pair are used to triangulate in on the target. Once the area surrounding the target is localized, the secondary pair are used to pinpoint that target.
To explain the basic concept of the Omnitron scanners, one must first understand
some very important basic facts. Instrumentation implementing electromagnetic
induction, RF induction, and gamma wave transmissions were thoroughly tested.
Much was learned about the effects of magnetics and ionization on all phases
of matter. Much of what was discovered was applied in developing the original scanner.
What was really unique was that the scanner had the ability to utilize air, oil or water
as the transmission media. Not only was the signal broadcast in a strictly horizontal
direction, but also in a spherical direction. One can only imagine being the center
of 3/4 mile sphere with that sphere being your probable target area!
Now once the signal is transmitted by the scann, the prospective target then
reciprocates with a complimentary and identical signal. Because of the fact that
the signals are identical, onl that element is being "tracked" by the scanner and
thereby eliminating the event of tracking unwanted targets. |
